Thiopentone

In this note:

Part of the classic RSI, thiopentone is one of the induction agents you’re most likely going to use for the first time in a crisis. Since it is seldom used anymore except in maternity or by old-school consultants, its worth knowing reasonably well. 

It has some genuinely neat chemistry—thiopentone shows tautomerism and switches between a water-soluble isomer when in the vial to a lipid soluble isomer in the body. 

Class and Use

 

Class: Thiobarbiturate

 

Use: Intravenous induction agent for anaesthesia

Special uses

      • Anticonvulsant: used in refractory status epilepticus
      • Neuroprotection: high-dose thiopental can be used to induce burst suppression for neuroprotection in high ICP or neurosurgery
      • Pregnancy: used in RSI of pregnancy 
Presentation and dose

 

Storage / preparation

  • Supplied as dry powder with sodium carbonate

  • It is a racemic mixture (of R and S enantiomers) and exhibits tautomerism

  • Tautomerism: thiopentone exists in its water-soluble enol form in alkaline solution, but shifts to its lipid-soluble keto form at physiological pH

  • Reconstitution: 500 mg sodium thiopental powder + 20 mL water → 25 mg/mL solution

Presentation

  • It is presented as a sodium salt → this makes it water-soluble but very alkaline (pH ~10.5–11).

    • This means, unlike propofol, its bacteriostatic

    • However, because it’s so alkaline, it’s dangerous if extravasated or injected intra-arterially

Dose 

  • Standard IV induction dose is 3-7mg/kg

  •  
Mechanism of Action

 

GABA-A receptor modulation

  • Thiopental is a positive allosteric modulator at the GABA-A receptor

  • It increases the duration of chloride (Cl⁻) channel opening

    • ↑ Cl⁻ influx → neuronal hyperpolarisation

    • reduced neuronal excitability and sedation

  • At high doses, it can directly activate the GABA-A receptor

Pharmacokinetics

 

Absorption 

  • Given IV – 100% bioavailability 

 

Distribution

  • pKa 7.6: so approx ~60% unionised at pH 7.4 → allowing rapid CNS penetration

  • Exists in its highly lipid-soluble keto form at physiological pH 

  • Protein binding: 80–85%

  • Vd: ~2–3.5 L/kg

  • Offset is due to redistribution (CNS → muscle and fat), not metabolism

 

Metabolism

  • Hepatic metabolism via CYP450 → to active and inactive metabolites

    • includes pentobarbital (an active oxybarbiturate metabolite)

  • Enzyme inducer (↑ CYP450 after single dose)

  • Zero-order kinetics possible at high plasma levels → due to saturation of metabolic pathways (not suitable for TIVA)

 

Excretion

  • Renally excreted

  • Clearance: ~3.5 mL/kg/min

Pharmacodynamics: effects and side-effects by system

 

Respiratory

  • Dose-dependent depression → often apnoea

  • May cause laryngospasm or bronchospasm

 

Cardiovascular

  • ↓ CO, ↓ SV, ↓ SVR (causing ↓ BP)

  • Baroreceptor reflex preserved → ↑ HR (compensatory tachycardia secondary to ↓BP)

 

Neurological

  • Rapid induction of anaesthesia in one arm brain time

  • ↓ CMRO₂, ↓ CBF, ↓ ICP, ↓ IOP

  • Anticonvulsant: used in status epilepticus

  • High-dose thiopentone can cause burst supression on EEG (which is useful in neuroprotection e.g. ↑ ICP)

 

Miscellaneous

  • Can cause tissue necrosis if extravasated (due to high pH) 

  • Absolutely contraindicated in porphyria (as it induces ALA synthase → may trigger acute attack)

  • ~1 in 20,000 risk of anaphylaxis 

  • Intra-arterial injection causes → vasospasm, thrombosis, necrosis
Intra-arterial Injection

 

We know by now that thiopental is supplied as a highly alkaline solution (pH ≈ 10.5–11) to make it water-soluble.

And once injected, at a physiological pH, the sodium thiopental solution converts back to its weakly soluble, unionised (ketone) form, which is poorly soluble in water

The result is:

  • Thiopental precipitates out as crystals in the arterial lumen

  • Crystals physically obstruct the vessel lumen and damage the endothelium

  • In addition, the alkaline pH itself is irritant and caustic, causing chemical injury to the intima

  • This initiates vasospasm and thrombus formation at the site

 

So why doesn’t this happen in venous injection?

  • Intravenously, thiopental mixes gradually with venous blood, allowing time for:

    • Dilution

    • Buffering by plasma proteins

    • Distribution before precipitation occurs

    • If any crystals do form, they are diluted and can re-dissolve within the high-volume venous circulation before reaching small arteries and causing spasm/occlusion 

 

Management of intra-arterial injection

  • Stop injection

  • High-volume saline dilution

  • Intra-arterial vasodilators: papaverine, procaine

  • Consider sympathetic block (e.g. stellate gangion block) to promote vasodilation

Related Posts

LaPlace’s law

Every hollow structure in the body holds a pressure. The left ventricle squeezes blood at well over 100 mmHg, arteries

Read More